Cisco UCS C Series 설치 매뉴얼 - 페이지 16

{카테고리_이름} Cisco UCS C Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS C Series 19 페이지. Security manager 4.3
Cisco UCS C Series에 대해서도 마찬가지입니다: 문제 해결 팁 (11 페이지), 업그레이드 매뉴얼 (11 페이지), 업그레이드 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (12 페이지), 설정 (10 페이지)

페이지 인쇄

Accessing the System BIOS

This server has the following NIC mode settings that you can choose from:

• Shared LOM EXT (default)—This is the shared LOM extended mode, the factory-default setting. With

• Shared LOM—The 1-Gb/10-Gb Ethernet ports are used to access Cisco IMC. You must select either the

• Dedicated—The dedicated management port is used to access Cisco IMC. You must select the None

• Cisco Card—The ports on an installed Cisco UCS Virtual Interface Card (VIC) are used to access the

This server has the following NIC redundancy settings that you can choose from:

• None—The Ethernet ports operate independently and do not fail over if there is a problem. This setting

• Active-standby—If an active Ethernet port fails, traffic fails over to a standby port. Shared LOM and

• Active-active (default)—All Ethernet ports are utilized simultaneously. The Shared LOM EXT mode

Accessing the System BIOS

Step 1

Enter the BIOS Setup Utility by pressing the F2 key when prompted during bootup.

Note

The version and build of the current BIOS are displayed on the Main page of the utility.

Step 2

Use the arrow keys to select the BIOS menu page.

Step 3

Highlight the field to be modified by using the arrow keys.

Step 4

Press Enter to select the field that you want to change, and then modify the value in the field.

Step 5

Press the right arrow key until the Exit menu screen is displayed.

Step 6

Follow the instructions on the Exit menu screen to save your changes and exit the setup utility (or press F10). You can

exit without saving changes by pressing Esc.

Installing the Server

this mode, the Shared LOM and Cisco Card interfaces are both enabled. You must select the default

Active-Active NIC redundancy setting in the following step.

In this NIC mode, DHCP replies are returned to both the shared LOM ports and the Cisco card ports. If

the system determines that the Cisco card connection is not getting its IP address from a Cisco UCS

Manager system because the server is in standalone mode, further DHCP requests from the Cisco card

are disabled. Use the Cisco Card NIC mode if you want to connect to Cisco IMC through a Cisco card

in standalone mode.

Active-Active or Active-standby NIC redundancy setting in the following step.

NIC redundancy setting in the following step.

Cisco IMC. You must select either the Active-Active or Active-standby NIC redundancy setting in the

following step.

See also the required VIC Slot setting below.

can be used only with the Dedicated NIC mode.

Cisco Card modes can each use either Active-standby or Active-active settings.

must use only this NIC redundancy setting. Shared LOM and Cisco Card modes can each use either

Active-standby or Active-active settings.

Installing the Server