Cisco UCS C220 M3 구성 매뉴얼 - 페이지 11

{카테고리_이름} Cisco UCS C220 M3에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS C220 M3 33 페이지. Security manager 4.3
Cisco UCS C220 M3에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (29 페이지), 업그레이드 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

Management Interfaces

You can use a web-based GUI or Secure Shell (SSH)–based command-line interface (CLI) to access, configure,

administer, and monitor the server. Almost all tasks can be performed in either interface, and the results of tasks

performed in one interface are displayed in the other. However, you cannot do the following:

●

Use the Cisco IMC GUI to invoke the Cisco IMC CLI

●

View a command that has been invoked through the Cisco IMC CLI in the Cisco IMC GUI

●

Generate Cisco IMC CLI output from the Cisco IMC GUI

Tasks You Can Perform in Cisco IMC

You can use the Cisco IMC to perform the following server management tasks:

●

Power on, power off, power cycle, reset, and shut down the server

●

Toggle the locator LED

●

Configure the server boot order

●

View server properties and sensors

●

Manage remote presence

●

Create and manage local user accounts and enable remote-user authentication through Microsoft Active

Creating Virtual Drives from Unused Physical Disks

A drive group is a group of physical drives. These drives are managed in partitions known as virtual drives.

A virtual drive is a partition in a drive group that is composed of contiguous data segments on the drives. A virtual

drive can consist of an entire drive group, multiple drive groups, an entire drive group plus parts of other drive

groups, a part of a drive group, parts of more than one drive group, or a combination of any two of these options.

Creating a RAID Volume Based on a Single Drive Group: RAID 0, 1, 5, and 6

Follow the steps presented here to create RAID volumes (virtual drives) from Cisco IMC.

Page 11 of 33