Cisco UCS C220 M3 구성 매뉴얼 - 페이지 30
{카테고리_이름} Cisco UCS C220 M3에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS C220 M3 33 페이지. Security manager 4.3
Cisco UCS C220 M3에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (29 페이지), 업그레이드 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (12 페이지)
페이지 인쇄
Step 9: After the reconstruction is complete, you can view the changed RAID level in the Virtual Drives pane.
Using the LSI MegaCLI Utility
The LSI MegaCLI utility can be used to obtain information from the LSI RAID controller. MegaCLI can also be used
to create RAID volumes, migrate the RAID level, and troubleshoot.
MegaCLI supports Microsoft Windows, Linux, VMware, Solaris, DOS, and free BSD. Download MegaCLI and unzip
the file. Then choose the right installation package for your operating system. For information about installation
procedures, problem fixes, and supported RAID controllers, see the 8.0.4.07_MegaCLI.txt file. This file is available
after you have unzipped the MegaCLI file. Detailed installation procedures can be found in the readme file
associated with each OS type.
To use the MegaCLI utility:
1.
Download the utility from LSI at this link: MegaCLI Utility.
2.
Install the utility on the server.
3.
Change the path to the location where MegaCLI is installed.
Note that you must enter megacli before every command, as shown in Figure 12. The command in the figure
shows the number of adapters (controllers) installed.
Figure 12.
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public.
Using MegaCLI
Page 30 of 33