Digitus DN-82010-1 사용자 설명서 - 페이지 3

{카테고리_이름} Digitus DN-82010-1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitus DN-82010-1 6 페이지. 10/100base-tx fast ethernet media converter
Digitus DN-82010-1에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지)

페이지 인쇄
Digitus DN-82010-1 사용자 설명서

4. Installing the Converter

Standalone unit:
→ Verify the AC-DC adapter conforms to your country AC power
requirement and insert the power plug
→ Connect the media cable for network connection
Slide-in unit:
→ The slide-in Media Converter and Converter Rack Chassis should
supplied only from the same source, both Media Converter Rack
Chassis are built to match each other at dimension, DC jack, DC
receptacle and power safety.
→ Turn off the 483mm (19") converter rack power
→ Ensure that there is no activity in the network
→ Locate +5V DC power jack on converter back, carefully slide in
and plug to 483mm (19") rack +5V DC power receptacle
→ Connect the media cable for network connection
→ Turn on the converter rack power, the Power LED will light up
Attach the fiber cable, the TX, RX fiber cable must be paired at both ends.
Fiber Port
Default: Full duplex mode
TP Port
Attach TP Cat.5 cable to TP Port
Wire connection, Front and Side panel
Fig. 1 Basic Network Connection