Cisco UCS Invicta C3124SA 설치 매뉴얼 - 페이지 26

{카테고리_이름} Cisco UCS Invicta C3124SA에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS Invicta C3124SA 40 페이지.
Cisco UCS Invicta C3124SA에 대해서도 마찬가지입니다: 업그레이드 절차 (16 페이지), 업그레이드 절차 (20 페이지)

페이지 인쇄

Installing the Cisco UCS Invicta C3124SA Appliance In a Rack

Figure 2-1

Front-right rack post

Rear-right rack post

Slide-rail assembly

Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail

assemblies are level and at the same height with each other.

Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops

and lock in place.

Insert the Cisco UCS Invicta C3124SA Appliance into the slide rails (see

Step 2

This Cisco UCS Invicta C3124SA Appliance weighs approximately 60 pounds (28 kilograms) when

Caution

fully loaded with components. We recommend that you use a minimum of two people when lifting the

Cisco UCS Invicta C3124SA Appliance. Attempting this procedure alone could result in personal injury

or equipment damage.

Note

Align the inner rails that are attached to the Cisco UCS Invicta C3124SA Appliance sides with the

front ends of the empty slide rails.

Push the Cisco UCS Invicta C3124SA Appliance into the slide rails until it stops at the internal

stops.

Push in the slide rail locking clip (item 2) on each inner rail, and then continue pushing the Cisco

UCS Invicta C3124SA Appliance into the rack until its front flanges latch onto the rack posts.

Cisco UCS Invicta C3124SA Appliance Installation Guide

2-6

Attaching a Slide-Rail Assembly

The inner rails are pre-attached to the sides of the Cisco UCS Invicta C3124SA Appliance at the

factory. You can order replacement inner rails if these are damaged or lost (Cisco PID

UCSC-RAIL-2U-I).

Chapter 2

Installing the Cisco UCS Invicta C3124SA Appliance

Length-adjustment bracket

Mounting pegs (two on each end of assembly)

Locking clips (one on each end of assembly)

Figure

2-2):

OL-31369-01