Setting Up the Chassis
For more information on cable specifications, refer to the online document Cisco Modular Access
Note
Router Cabling Specifications on the Documentation CD-ROM that accompanied your router
package and on Cisco.com. For cable ordering information, see
•
•
•
Setting Up the Chassis
You can set the chassis on a desktop, install it in a rack, or mount it on a wall or other flat surface. Use
the procedure in this section that best meets the needs of your network. The sections are as follows:
•
•
•
Cisco 2600 series routers include the following models:
•
•
•
•
•
•
•
•
Setting the Chassis on a Desktop
Before setting the router on a desktop, shelf, or other flat, secure surface, perform the following steps to
install the rubber feet:
Locate the rubber feet on the black adhesive strip that shipped with the chassis. (See
Step 1
Cisco 2600 Series Routers Hardware Installation Guide
3-2
Ethernet 10BASE-T hub or PC with a network interface card for connection to the Ethernet (LAN)
port(s).
Console terminal (an ASCII terminal or a PC running terminal emulation software) configured for
9600 baud, 8 data bits, no parity, and 2 stop bits. A terminal is required unless you are using the
AutoInstall procedure. See the
page 3-20
for instructions on connecting a console terminal.
Modem for connection to the auxiliary port for remote administrative access. (Optional)
Setting the Chassis on a Desktop, page 3-2
Mounting the Chassis in a Rack, page 3-4
Mounting the Chassis on the Wall, page 3-10
Cisco 2610 and Cisco 2610XM
Cisco 2611 and Cisco 2611XM
Cisco 2612 and Cisco 2613
Cisco 2620 and Cisco 2620XM
Cisco 2621 and Cisco 2621XM
Cisco 2650 and Cisco 2650XM
Cisco 2651 and Cisco 2651XM
Cisco 2691
"Connecting the Console Terminal and Modem" section on
Chapter 3
Installing the Router
"Obtaining Technical
Assistance".
Figure
3-1.)
OL-2171-02
페이지 인쇄