Cisco 2621 사용자 설명서 - 페이지 22

{카테고리_이름} Cisco 2621에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2621 35 페이지. Gateway-pbx interoperability: lucent/avaya definity g3si with e1 pri net5 signaling
Cisco 2621에 대해서도 마찬가지입니다: 운영 (25 페이지), 사용자 설명서 (20 페이지)

페이지 인쇄

Cisco 2651 Modular Access Routers

Figure 5

Once the router has been configured in to meet FIPS 140-1 Level 2 requirements, the router cannot be

accessed without signs of tampering. To seal the system, apply serialized tamper-evidence labels as

follows:

Step 1

Clean the cover of any grease, dirt, or oil before applying the tamper evidence labels. Alcohol-based

cleaning pads are recommended for this purpose. The temperature of the router should be above 10(C.

Step 2

Place the first label on the router as shown in

that the one half of the tamper evidence label covers the enclosure and the other half covers the side of

the router. Any attempt to remove the enclosure will leave tamper evidence.

Place the second label on the router as shown in

Step 3

so that the one half of the tamper evidence label covers the enclosure and the other half covers the side

of the router. Any attempt to remove the enclosure will leave tamper evidence.

Place the third label on the router as shown in

Step 4

that the one half of the label covers the enclosure and the other half covers the Network Module slot.

Any attempt to remove a network module will leave tamper evidence.

Step 5

Place the fourth label on the router as shown in

so that the half of the label covers the enclosure and the other half covers the WAN interface card slot.

Any attempt to remove a WAN interface card will leave tamper evidence.

Place the fifth label on the router as shown in

Step 6

that one half of the label covers the enclosure and the other half covers the WAN interface card slot.

Any attempt to remove a WAN interface card will leave tamper evidence.

The labels completely cure within five minutes.

Step 7

Cisco 2651 Modular Access Router Security Policy

Chassis Removal

POWER

RPS

ACTIVITY

Cisco 2600

SERIES

Figure

6. The tamper evidence label should be placed so

Figure

6. The tamper evidence label should be placed

Figure

6. The tamper evidence label should be placed so

Figure

6. The tamper evidence label should be placed

Figure

6. The tamper evidence label should be placed so

78-13697-01