Cisco 3800 Series 빠른 시작 매뉴얼 - 페이지 31

{카테고리_이름} Cisco 3800 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3800 Series 40 페이지. Password recovery procedure
Cisco 3800 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 문제 해결 매뉴얼 (15 페이지), 데이터시트 (20 페이지), 구성 (32 페이지), 사용자 설명서 (7 페이지)

페이지 인쇄

If the messages above do not appear, SDM and the Cisco Router and Security Device Manager (SDM) Quick Start Guide

Tip

were not shipped with your router. If you want to use SDM, you can download the latest version of SDM and

instructions for installing it on your router from the following location:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to www.cisco.com/go/sdm

and click the Technical Documentation link.

Initial Configuration Using the Setup Command Facility

This section shows how to use the setup command facility to configure a hostname for the router, set passwords, and configure

an interface for communication with the management network. If the following messages appear at the end of the startup

sequence, the setup command facility has been invoked automatically:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

The setup command facility prompts you for basic information about your router and network, and it creates an initial

configuration file. After the configuration file is created, you can use the CLI or Cisco Router and Security Device Manager

(SDM) to perform additional configuration.

The prompts in the setup command facility vary depending on your router model, the installed interface modules, and the

software image. The following example and the user entries (in

For help with interface and port numbering, see the "Port Numbering" section on page 29.

If you make a mistake while using the setup command facility, you can exit and run the setup command facility again.

Note

Press Ctrl-C, and type setup at the privileged EXEC mode prompt (Router#).

To proceed using the setup command facility, enter yes when the power-up messages have ended.

Step 1

Would you like to enter the initial configuration dialog? [yes/no]: yes

When the following messages appear, press Return to enter basic management setup:

Step 2

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity

for management of the system, extended setup will ask you

to configure each interface on the system

Would you like to enter basic management setup? [yes/no]: yes

Enter a hostname for the router (this example uses Router):

Step 3

Configuring global parameters:

Enter host name [Router]: Router

Step 4

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when you view the

configuration.

The enable secret is a password used to protect access to

privileged EXEC and configuration modes. This password, after

) are shown as examples only.

bold