Cisco ASR 5000 설치 매뉴얼 - 페이지 15

{카테고리_이름} Cisco ASR 5000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 5000 33 페이지. Applying power and verifying the installation
Cisco ASR 5000에 대해서도 마찬가지입니다: 설치 매뉴얼 (18 페이지), 설치 절차 (8 페이지), 설치 매뉴얼 (37 페이지)

페이지 인쇄
Cisco ASR 5000 설치 매뉴얼
Troubleshooting
Color
Description
None
No power is available to card.
OR
Link is down.
SPIO Interface – Activity LED States
The Activity LED associated with a particular SPIO interface indicates the presence of traffic on the network
link. This LED should be green when data is being transmitted or received over the interface.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 15: SPIO Interface Activity LED States
Color
Description
Flashing Green
Traffic is present on the link.
None
No traffic is present on the link.

Checking the LEDs on Ethernet Line Cards

The ASR 5000 can be equipped with a variety of Ethernet line cards that support subscriber traffic. For detailed
information about the types of line cards and their applications, refer to the ASR 5000 Installation Guide
The following line cards are currently supported on the ASR 5000:
• Fast Ethernet Line Card (FELC and FLC2): half-height, 8-ports, 10/100Base-T interfaces
• Gigabit Ethernet Line Card (GELC and GLC2): half-height, 1-ports, SFP interface
• Quad GigE Line Card (QGLC): half-height, 4-ports, SFP interfaces
• 10 Gigabit Line Card (XGLC): full-height, 1-port, SFP+ interfaces
Each of the Ethernet cards listed above is equipped with status LEDs as listed below:
• Run/Fail
• Active
• Standby
In addition to the LEDs listed above, each network interface is equipped with the Link and Activity LEDs.
The possible states for all LEDs on these Ethernet line cards are described below.
Troubleshooting
Verify that the Run/Fail LED is green. If so, the card is receiving power. If it
is off, the card is not receiving power.
Verify that the interface is cabled properly.
Verify that the device on which the interface is located is cabled and powered
properly.
Troubleshooting
None needed.
None needed if there is no activity on the link. Prior to configuration, this is
normal operation.
ASR 5000 System Administration Guide, StarOS Release 21.2
Checking the LEDs on Ethernet Line Cards
15