Cisco ASR 5000 설치 매뉴얼 - 페이지 31

{카테고리_이름} Cisco ASR 5000에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 5000 37 페이지. Applying power and verifying the installation
Cisco ASR 5000에 대해서도 마찬가지입니다: 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (33 페이지), 설치 절차 (8 페이지)

페이지 인쇄
Cisco ASR 5000 설치 매뉴얼
Applying Power and Verifying the Installation
Color
None
Checking the Alarm and Link LEDs on the Channelized Line Card 2
Each CLC2 provides alarm and link LEDs that indicate the status of each port. These LEDs are located at the
bottom of the front panel, as illustrated in the figure below.
Figure 8: Alarm/Link LEDs for the Channelized Line Card
Description
Troubleshooting
Card in Ready Mode
This is normal prior to configuration. Neither the Active nor
Standby LEDs on the card will be on.
OR
Card is not receiving
Verify that the Run/Fail LED is green. If so, the card is receiving
power OR Card in Active
power and POST test results are positive. If it is off, refer to
Mode
Channelized Line Card Run/Fail LED States, on page 29
troubleshooting information.
Check the state of the Active LED. If it is green, the card is in
standby mode.
Checking the Alarm and Link LEDs on the Channelized Line Card 2
ASR 5000 Installation Guide
for
31