Cisco ASR 9000 Series 구성 - 페이지 11

{카테고리_이름} Cisco ASR 9000 Series에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 46 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 구성 매뉴얼 (50 페이지), 매뉴얼 (24 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)

Cisco ASR 9000 Series 구성
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router

How to Configure Channelized SONET/SDH

This section contains the following procedures:

Configuring SONET T3 and VT1.5-Mapped T1 Channels

This task explains how to configure a SONET line into T3 and VT-mapped T1 Channels.
Prerequisites
Restrictions
T1s and E1s are not supported on the Cisco 1-Port Channelized OC-48/STM-16 SPA.
SUMMARY STEPS
1.
2.
3.
4.
OL-26061-03
Configuring SONET T3 and VT1.5-Mapped T1 Channels, page 327
Configuring Packet over SONET Channels, page 332
Configuring a Clear Channel SONET Controller for T3, page 335
Configuring Channelized SONET APS, page 338
Configuring SDH AU-3, page 341
Configuring SDH AU-4, page 349
You should know how to configure the SONET controller as specified in the
Clear Channel SONET Controllers"
on the Cisco ASR 9000 Series Router
STS paths can be channelized into T3s on the following SPAs:
Cisco 1-Port Channelized OC-48/STM-16 SPA
Cisco 1-Port Channelized OC-3/STM-1 SPA
Cisco 2-Port Channelized OC-12/DS0 SPA
STS paths can be channelized into VTG mapped T1s on the following SPA:
Cisco 1-Port Channelized OC-3/STM-1 SPA
Cisco 2-Port Channelized OC-12/DS0 SPA
T3 paths can be channelized into T1s or E1s on the following SPA:
Cisco 1-Port Channelized OC-3/STM-1 SPA
Cisco 2-Port Channelized OC-12/DS0 SPA
T1 paths can be channelized into NxDS0s on the Cisco 2-Port Channelized OC-12/DS0 SPA.
configure
controller sonet interface-path-id
clock source {internal | line}
framing sonet
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
How to Configure Channelized SONET/SDH
section of the
Configuring Clear Channel SONET Controllers
module.
"How to Configure
HC-327