Cisco ASR 9000 Series 구성 - 페이지 18

{카테고리_이름} Cisco ASR 9000 Series에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 46 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 구성 매뉴얼 (50 페이지), 매뉴얼 (24 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)

페이지 인쇄
Cisco ASR 9000 Series 구성
How to Configure Channelized SONET/SDH
Command or Action
Step 6
width number
Example:
RP/0/RSP0/CPU0:router(config-stsPath)#
width 3
Step 7
mode mode scramble
Example:
RP/0/RSP0/CPU0:router(config-stsPath)#
mode pos scramble
Step 8
root
Example:
RP/0/RSP0/CPU0:router(config-stsPath)#
root
Step 9
interface pos interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
POS 0/1/1/0
Step 10
encapsulation [hdlc | ppp | frame-relay
[IETF]]
Example:
RP/0/RSP0/CPU0:router(config-if)#
encapsulation hdlc
Step 11
pos crc {16 | 32}
Example:
RP/0/RSP0/CPU0:router(config-if)# pos crc
32
Step 12
mtu value
Example:
RP/0/RSP0/CPU0:router(config-if)# mtu
4474
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
HC-334
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Purpose
Configures the number of the STS streams that are concatenated.
The possible values for number are:
•
3—Indicating three STS streams (STS-3c)
•
12—Indicating concatenation of 12 STS streams (STS-12c)
•
48—Indicating concatenation of 48 STS streams (STS-48c)
Widths 3, 12, and 48 are configured on STS paths at natural
boundaries, which coincide with the following path numbers:
•
1, 4, 7, 10, and so on, for STS-3c
•
1, 13, 25, and 37 for STS-12c
1 for STS-48c
•
POS interfaces are not supported when width is 1.
Note
Sets the mode of interface at the STS level. Set the mode to pos to
create POS interface (OC12 and OC48 only).
Exits to global configuration mode.
Specifies the POS interface name and notation
rack/slot/module/port, and enters interface configuration mode.
(Optional) Configures the interface encapsulation parameters and
details such as HDLC or PPP. The default is HDLC.
(Optional) Configures the CRC value for the interface. Enter the 16
keyword to specify 16-bit CRC mode, or enter the 32 keyword to
specify 32-bit CRC mode.
The default CRC is 32.
(Optional) Configures the POS MTU value.
The range is 64–65535.
OL-26061-03