Cisco ASR 9000 Series 구성 - 페이지 19

{카테고리_이름} Cisco ASR 9000 Series에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 46 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 구성 매뉴얼 (50 페이지), 매뉴얼 (24 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)

페이지 인쇄
Cisco ASR 9000 Series 구성
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Command or Action
Step 13
no shutdown
Example:
RP/0/RSP0/CPU0:router (config-if)# no
shutdown
Step 14
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-sonet)# end
or
RP/0/RSP0/CPU0:router(config-sonet)#
commit
Step 15
show interfaces pos interface-path-id
Example:
RP/0/0/CPU0:router# show interfaces pos
0/1/1/0

Configuring a Clear Channel SONET Controller for T3

This task explains how to configure a SONET line into a single T3 serial channel called clear channel.
Clear channel is established by setting the T3 controller mode to serial.
Prerequisites
•
SUMMARY STEPS
1.
2.
3.
OL-26061-03
You should know how to configure the SONET controller as specified in the
Clear Channel SONET Controllers"
on the Cisco ASR 9000 Series Router
configure
controller sonet interface-path-id
clock source {internal | line}
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Purpose
Removes the shutdown configuration.
Note
Removal of the shutdown configuration eliminates the
forced administrative down on the interface, enabling it to
move to an up or down state (assuming that the parent
SONET layer is not configured administratively down).
Saves configuration changes.
When you issue the end command, the system prompts you to
•
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to the running
–
configuration file, exits the configuration session, and
returns the router to EXEC mode.
Entering no exits the configuration session and returns the
–
router to EXEC mode without committing the
configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or committing the
configuration changes.
Use the commit command to save the configuration changes to
•
the running configuration file and remain within the
configuration session.
(Optional) Displays the interface configuration.
section of the
Configuring Clear Channel SONET Controllers
module.
How to Configure Channelized SONET/SDH
"How to Configure
HC-335