- ページ 19

ゲートウェイ Cisco ASR 9000 SeriesのPDF 設定をオンラインで閲覧またはダウンロードできます。Cisco ASR 9000 Series 46 ページ。 Line card
Cisco ASR 9000 Series にも： ネットワーク設定の構成 (26 ページ), 設定マニュアル (46 ページ), 設定マニュアル (50 ページ), マニュアル (24 ページ), マニュアル (44 ページ), クイック・リファレンス・マニュアル (7 ページ)

ページを印刷する
Cisco ASR 9000 Series 設定
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Command or Action
Step 13
no shutdown
Example:
RP/0/RSP0/CPU0:router (config-if)# no
shutdown
Step 14
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-sonet)# end
or
RP/0/RSP0/CPU0:router(config-sonet)#
commit
Step 15
show interfaces pos interface-path-id
Example:
RP/0/0/CPU0:router# show interfaces pos
0/1/1/0

Configuring a Clear Channel SONET Controller for T3

This task explains how to configure a SONET line into a single T3 serial channel called clear channel.
Clear channel is established by setting the T3 controller mode to serial.
Prerequisites
•
SUMMARY STEPS
1.
2.
3.
OL-26061-03
You should know how to configure the SONET controller as specified in the
Clear Channel SONET Controllers"
on the Cisco ASR 9000 Series Router
configure
controller sonet interface-path-id
clock source {internal | line}
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Purpose
Removes the shutdown configuration.
Note
Removal of the shutdown configuration eliminates the
forced administrative down on the interface, enabling it to
move to an up or down state (assuming that the parent
SONET layer is not configured administratively down).
Saves configuration changes.
When you issue the end command, the system prompts you to
•
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to the running
–
configuration file, exits the configuration session, and
returns the router to EXEC mode.
Entering no exits the configuration session and returns the
–
router to EXEC mode without committing the
configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or committing the
configuration changes.
Use the commit command to save the configuration changes to
•
the running configuration file and remain within the
configuration session.
(Optional) Displays the interface configuration.
section of the
Configuring Clear Channel SONET Controllers
module.
How to Configure Channelized SONET/SDH
"How to Configure
HC-335