Cisco Physical Access CIAC-GW-K9 설치 및 구성 - 페이지 8
{카테고리_이름} Cisco Physical Access CIAC-GW-K9에 대한 설치 및 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Physical Access CIAC-GW-K9 26 페이지. Physical access gateway
Cisco Physical Access CIAC-GW-K9에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
Installing the Cisco Physical Access Gateway
Figure 2-4
1
DC power GND (ground)— Connects the DC ground wire to the Gateway.
2
DC power Voltage In (VIN)—Connects the DC Voltage In (VIN) wire to the Gateway.
3
ETH0 for PoE—Connects the Ethernet cable from the Access Layer switch to the Gateway. To
use this power option, the switch must support PoE.
Connect one or two door reader devices to the Wiegand interface using one of the following
Step 3
configurations:
•
Connect a single door reader using all 10 Wiegand interface pins.
Connect one or two door readers using 5-pin Wiegand interface connections (for installations where
•
a 5-pin interface is sufficient).
Cisco Physical Access Gateway User Guide
2-8
Chapter 2
Power Connections for the Cisco Physical Access Gateway
3
Installing and Configuring the Cisco Physical Access Gateway
1
2
OL-32499-01