Cisco Physical Access CIAC-GW-K9 Kurulum ve Yapılandırma - Sayfa 8
Ağ Geçidi Cisco Physical Access CIAC-GW-K9 için çevrimiçi göz atın veya pdf Kurulum ve Yapılandırma indirin. Cisco Physical Access CIAC-GW-K9 26 sayfaları. Physical access gateway
Ayrıca Cisco Physical Access CIAC-GW-K9 için: Hızlı Başlangıç Kılavuzu (17 sayfalar)
Sayfayı Yazdır
Installing the Cisco Physical Access Gateway
Figure 2-4
1
DC power GND (ground)— Connects the DC ground wire to the Gateway.
2
DC power Voltage In (VIN)—Connects the DC Voltage In (VIN) wire to the Gateway.
3
ETH0 for PoE—Connects the Ethernet cable from the Access Layer switch to the Gateway. To
use this power option, the switch must support PoE.
Connect one or two door reader devices to the Wiegand interface using one of the following
Step 3
configurations:
•
Connect a single door reader using all 10 Wiegand interface pins.
Connect one or two door readers using 5-pin Wiegand interface connections (for installations where
•
a 5-pin interface is sufficient).
Cisco Physical Access Gateway User Guide
2-8
Chapter 2
Power Connections for the Cisco Physical Access Gateway
3
Installing and Configuring the Cisco Physical Access Gateway
1
2
OL-32499-01