Cisco VG202 소프트웨어 구성 매뉴얼 - 페이지 37

{카테고리_이름} Cisco VG202에 대한 소프트웨어 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco VG202 50 페이지. Voice gateways
Cisco VG202에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (50 페이지), 매뉴얼 (10 페이지), 하드웨어 설치 매뉴얼 (48 페이지), 빠른 시작 매뉴얼 (19 페이지)

페이지 인쇄

1. Upgrading to a New Cisco Ios Release

Chapter 4

Configuring Voice

Table 4-1

Port Number

0/0

0/1

0/2

0/3

Configuring Calls

This section provides information and provisions for configuring calls on the VG202 and VG204 voice

gateways. The following functions are covered:

•

Call Transfer

The VG202 or VG204 voice gateways blind-call transfer functionality allows the transfer of a call from

the party you call to a destination caller without and call commit from the original person called. For

example, party A (transferee) calls party B (transferor). The transferor wants to transfer the call to party

C (transfer-target) and uses hookflash (softkey transfer) to get a dial tone, and then dials party C's

number. When CCM gets party C's number, it transfers the party A call to party C without the need of

committment from party B.

The VG202 or VG204 voice gateways consultation call transfer functionality allows happens after a call

is established between a transferor and transferee. The transferor wants to transfer the call to a transfer

target by using a softkey transfer by getting a dialtone then dialing the transfer-target's phone number.

When the call between the transferor and transfer-target is established, the transferor hangs up the phone

to commit the transfer. The CCM connects the call between the transferee and the transfer-target.

To configure call transfer on the voice gateways, use the following commands.

SUMMARY STEPS

OL-16191-01

Voice Port to MAC Address Conversion Chart

Last Three Digits of the MAC

Address

000

001

002

003

Call Transfer, page 4-11

Call Waiting, page 4-12

Three-Party Conferencing, page 4-13

Call ID, page 4-13

enable

configure terminal

dial-peer voice tags pots

service stcapp

port port-number

exit

Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide

Configuring Calls

4-11