Cisco VG202 빠른 시작 매뉴얼 - 페이지 16

{카테고리_이름} Cisco VG202에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco VG202 19 페이지. Voice gateways
Cisco VG202에 대해서도 마찬가지입니다: 소프트웨어 구성 매뉴얼 (50 페이지), 하드웨어 설치 매뉴얼 (50 페이지), 매뉴얼 (10 페이지), 하드웨어 설치 매뉴얼 (48 페이지)

페이지 인쇄

Enter the username cisco, and press Return or Enter.

Step 3

The system displays the following prompt:

Password:

Enter the password cisco, and press Return or Enter.

Step 4

The system displays the following prompt:

VG#

You are now in privileged EXEC mode.

The system prompts you to change the username and password.

You must change the username and password before you log off the voice gateway. You cannot use the

Note

username cisco or password cisco after you log off from this session.

To change the username and password, enter the following at the prompt:

Step 5

username username privilege 15 secret 0 password

Where username and password are the username and password that you wish to use.

Step 6

Use the copy running-config startup-config command at the privileged EXEC mode prompt (

configuration to NVRAM.

Configuring the Voice Gateway by Using the setup Command

Before You Begin

Perform the procedure in

Procedure

In privileged EXEC mode, at the prompt, enter the setup command facility.

Step 1

yourname# setup

The system displays the following message:

--- System Configuration Dialog ---

Continue with configuration dialog? [yes/no]:

You are now in the setup command facility.

The prompts in the setup command vary, depending on the voice gateway model, on the installed interface modules,

and on the software image. The following steps and the user entries (in bold) are shown as examples only.

If you make a mistake while using the setup command, you can exit and run the setup command again. Press

Note

Ctrl-C, and enter the setup command at the privileged EXEC mode prompt (

To proceed using the setup command, enter yes:

Step 2

Continue with configuration dialog? [yes/no]: yes

When the following messages appear, enter yes to enter basic management setup:

Step 3

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Configuring the Voice Gateway by Using the Cisco IOS

) to save the

VG#

CLI.

VG#