Epson Stylus Scan 2500 여기에서 시작 - 페이지 2

{카테고리_이름} Epson Stylus Scan 2500에 대한 여기에서 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Scan 2500 4 페이지. Epson imaging products (scanners, digital cameras, and stylus scan devices) compatibility chart for macintosh os x classic
Epson Stylus Scan 2500에 대해서도 마찬가지입니다: 사용자 설명서 (7 페이지), 제품 정보 시트 (4 페이지), 사양 (2 페이지), 제품 정보 시트 (4 페이지), 제품 지원 게시판 (12 페이지), 제품 정보 (12 페이지), 여기에서 시작 (4 페이지), 매뉴얼 (11 페이지), 제품 지원 게시판 (3 페이지), 부품 목록 (9 페이지), 설정 매뉴얼 (35 페이지), 온라인 매뉴얼 (10 페이지), 추가 정보 (12 페이지)

페이지 인쇄
Epson Stylus Scan 2500 여기에서 시작
5
Install the ink cartridges
1. Press the
3. Unwrap the ink cartridges. Then
pull off only the yellow part of
the tape seal on top. Don't pull
off the blue portion or remove
the clear seal on the bottom of
the cartridge.
If ink gets on your hands, wash them thoroughly with
WARNING
soap and water. If ink gets in your eyes, flush them
immediately with water. Keep ink cartridges out of the reach of children.
4. Lift up the ink cartridge clamps.
6. Press down on the ink
cartridge clamps until they
lock into place.
7. Close the maintenance and document covers.
Charging takes about 2 minutes. The
makes various sounds. Don't turn off the printer yet. Wait until the
light stops flashing and stays on.
Don't open the clamps to remove a cartridge except to
CAUTION
replace it with a new one. Once you remove a cartridge,
you can't reuse it, even if it contains ink. You must install both cartridges and leave
them installed for all types of printing. To avoid damaging the printer, never move
the print head by hand.
Operate button.
The Operate light comes on and
the print head moves.
2. Open the document and
maintenance covers, if
necessary.
5. Insert the ink cartridges with
the labels face-up. Don't
press down on the cartridges.
8. Press the
cleaning button to
begin charging the ink delivery
system.
Operate light flashes and the printer
Operate
6
Load paper in the tray
1. Slide out the edge guide.
3. Place a stack of
paper against the
right side of the
feeder.
4. Make sure the paper fits under the
arrow mark inside the edge guide. Slide
the edge guide against the paper.
Test your
7
EPSON Stylus Scan
1. Turn off the printer.
2. Hold down the
load/eject button.
When you release the buttons, the nozzle check page starts to print. This is
what it should look like:
If it doesn't look right, you may need to run a print head cleaning cycle. See
your User's Guide for instructions. If it doesn't print, see "Solving Problems"
in your User's Guide.
o o v v e e r r
turn
2. Slide out the tray
extension.
3. Press the
Operate
button.