Epson Stylus Scan 2500 Start Here - Page 2

Browse online or download pdf Start Here for Scanner Epson Stylus Scan 2500. Epson Stylus Scan 2500 4 pages. Epson imaging products (scanners, digital cameras, and stylus scan devices) compatibility chart for macintosh os x classic
Also for Epson Stylus Scan 2500: User Manual (7 pages), Product Information Sheet (4 pages), Specifications (2 pages), Product Information Sheet (4 pages), Product Support Bulletin (12 pages), Product Information (12 pages), Start Here (4 pages), Manual (11 pages), Product Support Bulletin (3 pages), Parts List (9 pages), Setup Manual (35 pages), Online Manual (10 pages), Supplemental Information (12 pages)

Print Page

Install the ink cartridges

1. Press the

3. Unwrap the ink cartridges. Then

pull off only the yellow part of

the tape seal on top. Don't pull

off the blue portion or remove

the clear seal on the bottom of

the cartridge.

If ink gets on your hands, wash them thoroughly with

WARNING

soap and water. If ink gets in your eyes, flush them

immediately with water. Keep ink cartridges out of the reach of children.

4. Lift up the ink cartridge clamps.

6. Press down on the ink

cartridge clamps until they

lock into place.

7. Close the maintenance and document covers.

Charging takes about 2 minutes. The

makes various sounds. Don't turn off the printer yet. Wait until the

light stops flashing and stays on.

Don't open the clamps to remove a cartridge except to

CAUTION

replace it with a new one. Once you remove a cartridge,

you can't reuse it, even if it contains ink. You must install both cartridges and leave

them installed for all types of printing. To avoid damaging the printer, never move

the print head by hand.

Operate button.

The Operate light comes on and

the print head moves.

2. Open the document and

maintenance covers, if

necessary.

5. Insert the ink cartridges with

the labels face-up. Don't

press down on the cartridges.

8. Press the

cleaning button to

begin charging the ink delivery

system.

Operate light flashes and the printer

Operate

Load paper in the tray

1. Slide out the edge guide.

3. Place a stack of

paper against the

right side of the

feeder.

4. Make sure the paper fits under the

arrow mark inside the edge guide. Slide

the edge guide against the paper.

Test your

EPSON Stylus Scan

1. Turn off the printer.

2. Hold down the

load/eject button.

When you release the buttons, the nozzle check page starts to print. This is

what it should look like:

If it doesn't look right, you may need to run a print head cleaning cycle. See

your User's Guide for instructions. If it doesn't print, see "Solving Problems"

in your User's Guide.

o o v v e e r r

turn

2. Slide out the tray

extension.

3. Press the

Operate

button.