Epson 2000P - Stylus Photo Color Inkjet Printer 제품 정보 - 페이지 7

{카테고리_이름} Epson 2000P - Stylus Photo Color Inkjet Printer에 대한 제품 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 2000P - Stylus Photo Color Inkjet Printer 13 페이지. Product support bulletin(s)
Epson 2000P - Stylus Photo Color Inkjet Printer에 대해서도 마찬가지입니다: 설정 매뉴얼 (17 페이지), 카트리지 교체 (2 페이지), 제품 지원 게시판 (6 페이지), 제품 지원 게시판 (1 페이지), 사양 (1 페이지), 사용자 설명서 (12 페이지), 제품 지원 게시판 (3 페이지), 제품 지원 게시판 (2 페이지), 제품 지원 게시판 (4 페이지), 제품 지원 게시판 (7 페이지), 빠른 시작 매뉴얼 (2 페이지), 설치 지침 매뉴얼 (8 페이지)

Loading Roll Paper

When loading roll paper, be sure to follow the instructions in

this section. Also, make sure

Paper Source in the printer driver.

1. Before loading the roll,

make sure the edge is cut

cleanly—at a 90-degree

angle in each corner—to

ensure proper loading. If

necessary, trim the edge

using a straight-edge tool.

2. To make loading easier, roll the first several inches of the

paper backward to uncurl it. Use the plastic sheet included

with your printer to prevent your hands from marring the

printable surface. (Or you can use a folded sheet of paper.)

3. Remove the printer's paper support and install the roll

paper holder in the same mounting slots.

4. Insert the roll paper onto the spindle, making sure it's

oriented as shown here. Then place the spindle with the roll

paper onto the holder.

is selected as your

Roll Paper

5. Load the end of the paper into the printer as far as it will go,

then slide the left edge guide against the paper.

6. Gently hold the paper in place as you press and release the

E load/eject button to feed the paper into the printer. Avoid

handling the paper excessively, to prevent contamination

with dirt or grease.

(If the paper doesn't feed properly, lift the paper out and

then reload it. If the paper doesn't come out easily, hold

down the E load/eject button for three seconds. Then turn

the printer off, remove the paper, and turn the printer back

on to reset it. When reloading, make sure the end is cut

straight and not curled or damaged. If necessary, re-trim the

paper as shown in step 1.)

7. Make sure the output tray is open but the extensions are

closed, and leave ample room at the front of the printer for

your paper to eject smoothly.

6/00

EPSON Stylus Photo 2000P

- 7