Epson 2000P - Stylus Photo Color Inkjet Printer Product Information - Page 7

Browse online or download pdf Product Information for Printer Accessories Epson 2000P - Stylus Photo Color Inkjet Printer. Epson 2000P - Stylus Photo Color Inkjet Printer 13 pages. Product support bulletin(s)
Also for Epson 2000P - Stylus Photo Color Inkjet Printer: Setup Manual (17 pages), Cartridges Replacement (2 pages), Product Support Bulletin (6 pages), Product Support Bulletin (1 pages), Specifications (1 pages), User Manual (12 pages), Product Support Bulletin (3 pages), Product Support Bulletin (2 pages), Product Support Bulletin (4 pages), Product Support Bulletin (7 pages), Quick Start Manual (2 pages), Installation Instructions Manual (8 pages)

Print Page

Loading Roll Paper

When loading roll paper, be sure to follow the instructions in

this section. Also, make sure

Paper Source in the printer driver.

1. Before loading the roll,

make sure the edge is cut

cleanly—at a 90-degree

angle in each corner—to

ensure proper loading. If

necessary, trim the edge

using a straight-edge tool.

2. To make loading easier, roll the first several inches of the

paper backward to uncurl it. Use the plastic sheet included

with your printer to prevent your hands from marring the

printable surface. (Or you can use a folded sheet of paper.)

3. Remove the printer's paper support and install the roll

paper holder in the same mounting slots.

4. Insert the roll paper onto the spindle, making sure it's

oriented as shown here. Then place the spindle with the roll

paper onto the holder.

is selected as your

Roll Paper

5. Load the end of the paper into the printer as far as it will go,

then slide the left edge guide against the paper.

6. Gently hold the paper in place as you press and release the

E load/eject button to feed the paper into the printer. Avoid

handling the paper excessively, to prevent contamination

with dirt or grease.

(If the paper doesn't feed properly, lift the paper out and

then reload it. If the paper doesn't come out easily, hold

down the E load/eject button for three seconds. Then turn

the printer off, remove the paper, and turn the printer back

on to reset it. When reloading, make sure the end is cut

straight and not curled or damaged. If necessary, re-trim the

paper as shown in step 1.)

7. Make sure the output tray is open but the extensions are

closed, and leave ample room at the front of the printer for

your paper to eject smoothly.

6/00

EPSON Stylus Photo 2000P

- 7