Epson 2000P - Stylus Photo Color Inkjet Printer Product Information - Page 5

Browse online or download pdf Product Information for Printer Accessories Epson 2000P - Stylus Photo Color Inkjet Printer. Epson 2000P - Stylus Photo Color Inkjet Printer 13 pages. Product support bulletin(s)
Also for Epson 2000P - Stylus Photo Color Inkjet Printer: Setup Manual (17 pages), Cartridges Replacement (2 pages), Product Support Bulletin (6 pages), Product Support Bulletin (1 pages), Specifications (1 pages), User Manual (12 pages), Product Support Bulletin (3 pages), Product Support Bulletin (2 pages), Product Support Bulletin (4 pages), Product Support Bulletin (7 pages), Quick Start Manual (2 pages), Installation Instructions Manual (8 pages)

Print Page

Epson 2000P - Stylus Photo Color Inkjet Printer Product Information

2. Lift up the two ink cartridge clamps.

3. Unwrap the ink cartridges, then remove only the yellow

part of the tape seal on top.

black ink

color ink

cartridge

4. Tilt each cartridge forward slightly as you lower it into its

holder. Hang the tabs at the back of the cartridge on the

hooks on the holder clamps.

tabs

hooks

Don't place the cartridges under the holder clamp; you

may damage the clamp when you close it.

5. Close the ink cartridge clamps. (The color clamp is a bit

harder to close.)

6. Press the yellow ink cartridge replacement button (shown in

step 1) and close the printer cover.

Ink charging takes about three minutes, with the P power

light flashing and the printer making noise until it's finished.

Don't turn off the printer or interrupt charging or it will start

over, using more ink than necessary. It's finished when the

P power light stops flashing.

Testing the Printer

You can run a printer check to determine whether a problem

comes from the printer itself or some other source. Follow

these steps to run the printer check:

1. Make sure both the printer and computer are turned off.

don't touch the

2. Disconnect the interface cable from the printer.

green chips

3. Make sure letter-size or larger paper is loaded in the printer.

4. Hold down the E load/eject button, then press and release

the Ppower button. Continue holding down the

E load/eject button until the Ppower light starts to flash,

then release it.

The printer prints one page showing its ROM version

number, ink counter, and a nozzle check pattern. Only the

nozzle check pattern is shown below. (If the pattern has

gaps in its dots, you need to clean the print head; see

page 9.)

5. To end the check, turn off the printer after it prints the

check page. Then reconnect the interface cable and turn on

your printer and computer.

If the check page prints, the problem probably lies in your

software settings, the interface cable, or your computer.

If the check page doesn't print, you may have a problem with

your printer.

Try the suggestions in "Problems and Solutions" in the Printer

Basics book.

6/00

EPSON Stylus Photo 2000P

The printer's first ink cartridges won't last as long as the

replacements. This is because the printer uses more ink

when charging the print head for the first time.

EPSON Stylus Photo 2000P

- 5