Epson FX-880+ 설정 매뉴얼 - 페이지 27

{카테고리_이름} Epson FX-880+에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson FX-880+ 33 페이지. Epson serial impact dot matrix printers
Epson FX-880+에 대해서도 마찬가지입니다: 브로셔 및 사양 (24 페이지), 매뉴얼 (18 페이지), 사양 (2 페이지), 먼저 읽어보기 (2 페이지), 참조 매뉴얼 (34 페이지), 빠른 매뉴얼 (33 페이지)

페이지 인쇄

If you use an extension cord with the printer, make sure the

total ampere rating of all devices plugged into the extension

cord does not exceed the cord's ampere rating. Also, make

sure the total ampere of all devices plugged into the wall

outlet does not exceed the wall outlet's ampere rating.

Unplug the printer before cleaning it, and always clean it with

a piece of damp cloth only.

Do not spill liquid onto the printer.

Except as specifically explained in this guide, do not attempt

to service the printer yourself.

Unplug the printer and refer servicing to qualified service

personnel under the following conditions:

i. If the power cord or plug is damaged.

ii. If liquid has entered the printer.

iii. If the printer has been dropped or the cabinet damaged.

iv. If the printer does not operate normally or exhibits a

distinct change in performance.

If you plan to use the printer in Germany, observe the

following:

To provide adequate short-circuit protection and

over-current protection for this printer, the building

installation must be protected by a 10- or 16-amp circuit

breaker.

Note for German-speaking users:

Bei Anschluss des Druckers an die Stromversorgung muss

sichergestellt werden, dass die Gebaudeinstallation mit einer 10 A-

oder 16 A-Sicherung abgesichert ist.

Safety and Environmental Information