TomTom Mazda NB1 참조 매뉴얼 - 페이지 4

{카테고리_이름} TomTom Mazda NB1에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. TomTom Mazda NB1 33 페이지. For mazda cx-5 2014
TomTom Mazda NB1에 대해서도 마찬가지입니다: 음성 인식 지침 (11 페이지), 소유자 매뉴얼 (48 페이지)

페이지 인쇄

Read me first

Switching on and off

Your Mazda NB1 switches on when your car engine starts and switches off automatically when

you turn off your car's engine.

Until a connection has been established between the car and the Mazda NB1, the screen shows

audio-related information and the NAV button on the main display is inactive. In some situations

when you start the car, the navigation device may restart. If this happens, press the NAV button. A

black screen is shown and it make take up to 30 seconds for the main screen to appear.

Under extreme temperature conditions, the navigation device may not start. When the

temperature is within the normal range again, the device should start. If the device fails to start

automatically in this situation, stop your car engine and start the car engine again.

Note: In some situations, your navigation system may restart when turning your key in the

ignition from ACC-ON to the engine start position. If this happens, it may take up to 30 seconds

for the main screen to appear on the navigation system.

Setting up

Important: Take care to select the correct language as the language you choose will be used for

all text on the screen.

When you first switch on your device, you have to answer a few questions to set up the device.

Answer the questions by tapping the screen.

GPS reception

When you first start your Mazda NB1 navigation device, the device may need a few minutes to

determine your GPS position and show your current position on the map. In future, your position

will be found much faster, usually within a few seconds.

In areas where GPS reception is not possible, such as tunnels, your location may not be accurate.

Important: The GPS antenna is located in the dashboard so do not put objects on the dashboard.

Device not starting

In rare cases, your TomTom navigation module may not start correctly or may stop responding to

your taps. For example, if the device temperature is too high or too low, the system shuts down.

In rare circumstances, you may need to reset your navigation device. To reset your device, switch

off the car engine and then remove the memory card. Re-insert the memory card and switch the

car engine on again.