Epson LQ-1170 제품 지원 게시판 - 페이지 5
{카테고리_이름} Epson LQ-1170에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson LQ-1170 16 페이지. Understanding and using escp/3 commands and syntax
Epson LQ-1170에 대해서도 마찬가지입니다: 매뉴얼 (5 페이지), 제품 지원 게시판 (20 페이지), 제품 지원 게시판 (5 페이지), 기술 요약 (7 페이지), 설치 매뉴얼 (1 페이지), 조립 설명서 (8 페이지), 제품 지원 게시판 (20 페이지)
페이지 인쇄
ESC ( C m1 m2 n1 n2 (Set Page Length in Defined Units
ml =2 and m2=0.
To determine the values for n1 and n2 perform the following steps.
1.
Determine the desired page length in inches.
2
Multiply the page length by 380.
Divide the result by 256 using long division.
3.
4.
The remainder in the quotient from step 3 is the value for n1.
5.
The whole number in the quotient from step 3 is the value for n2.
EXAMPLE
1.
The page length is 8.5 inches.
2
8.5 x 380 = 3060
3.
3080 divided by 258 = 11 with a remainder of 244.
4.
5.
In the Basic programming language, the command would look like this.
This command, as listed in the line above, will set the page length to 8.5 inches.
NOTE: The current line becomes the top of form. This command cancels any
previously set top and bottom margin settings. If you wish to set the top and bottom
margins via software command, the commands must be issued AFTER the "Set Page
Length in Defined Units" command. The proper page length setting can be confirmed
by issuing a "Form Feed" command, chr$(l2), or by pressing the "FF button on the
control panel while the printer is "Cff Line".
PSB No: P-0082
Page: 5 of 14