Epson LQ-1170 Бюллетень поддержки продуктов - Страница 5

Просмотреть онлайн или скачать pdf Бюллетень поддержки продуктов для Аксессуары для принтеров Epson LQ-1170. Epson LQ-1170 16 страниц. Understanding and using escp/3 commands and syntax
Также для Epson LQ-1170: Руководство (5 страниц), Бюллетень поддержки продуктов (20 страниц), Бюллетень поддержки продуктов (5 страниц), Технический обзор (7 страниц), Руководство по установке (1 страниц), Руководство по сборке (8 страниц), Бюллетень поддержки продуктов (20 страниц)

Печатать страницу
Epson LQ-1170 Бюллетень поддержки продуктов
ESC ( C m1 m2 n1 n2 (Set Page Length in Defined Units
ml =2 and m2=0.
To determine the values for n1 and n2 perform the following steps.
1.
Determine the desired page length in inches.
2
Multiply the page length by 380.
Divide the result by 256 using long division.
3.
4.
The remainder in the quotient from step 3 is the value for n1.
5.
The whole number in the quotient from step 3 is the value for n2.
EXAMPLE
1.
The page length is 8.5 inches.
2
8.5 x 380 = 3060
3.
3080 divided by 258 = 11 with a remainder of 244.
4.
5.
In the Basic programming language, the command would look like this.
This command, as listed in the line above, will set the page length to 8.5 inches.
NOTE: The current line becomes the top of form. This command cancels any
previously set top and bottom margin settings. If you wish to set the top and bottom
margins via software command, the commands must be issued AFTER the "Set Page
Length in Defined Units" command. The proper page length setting can be confirmed
by issuing a "Form Feed" command, chr$(l2), or by pressing the "FF button on the
control panel while the printer is "Cff Line".
PSB No: P-0082
Page: 5 of 14