Epson LQ-570e 매뉴얼 - 페이지 8

{카테고리_이름} Epson LQ-570e에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson LQ-570e 12 페이지. Epson serial impact dot matrix printers
Epson LQ-570e에 대해서도 마찬가지입니다: 제품 정보 매뉴얼 (8 페이지), 빠른 참조 매뉴얼 (15 페이지), 제품 정보 매뉴얼 (18 페이지), 사양 (2 페이지), 조립 설명서 (8 페이지), 제품 지원 게시판 (16 페이지), 참조 매뉴얼 (34 페이지)

Adjusting for Different Top and Bottom Margins

The LQ-570e allows for smaller top and bottom margins—4.2 mm

(.17 inch) for both—increasing the maximum printable area on the

page. You will not notice any difference in printing unless you

have specified margins in your software applications that are less

than the minimum allowed by the LQ-570+ (5.3 mm [.2 inch] for

the top and 9 mm [.35 inch] for the bottom). In this case you may

need to adjust your top and bottom margin settings through your

software or by adjusting the top-of-form position. See your

LQ-570e User's Guide.

Adjusting the Loading (Top-of-Form) and Tear-off

Positions with Micro Adjust

The LQ-570+ micro-feed feature is now called the Micro Adjust

mode on the LQ-570e. To adjust the top-of-form or tear-off

position, make sure paper is loaded in the printer. Then hold

down the Pause button for 3 seconds to enter Micro Adjust

mode. Make sure the Pause light is flashing. Then press the

Load/Eject

are done, press Pause again.

The LQ 570e has no DIP switches. The functions defined by DIP

switch settings on the LQ-570+ are now selected through the

Default Setting Mode on the LQ-570e. See the following section.

or LF/FF

button to adjust the position. When you