Epson LQ-570e Manuel - Sayfa 8

Yazıcı Aksesuarları Epson LQ-570e için çevrimiçi göz atın veya pdf Manuel indirin. Epson LQ-570e 12 sayfaları. Epson serial impact dot matrix printers
Ayrıca Epson LQ-570e için: Ürün Bilgi Kılavuzu (8 sayfalar), Hızlı Referans Kılavuzu (15 sayfalar), Ürün Bilgi Kılavuzu (18 sayfalar), Teknik Özellikler (2 sayfalar), Montaj Kılavuzu (8 sayfalar), Ürün Destek Bülteni (16 sayfalar), Referans Kılavuzu (34 sayfalar)

Adjusting for Different Top and Bottom Margins

The LQ-570e allows for smaller top and bottom margins—4.2 mm

(.17 inch) for both—increasing the maximum printable area on the

page. You will not notice any difference in printing unless you

have specified margins in your software applications that are less

than the minimum allowed by the LQ-570+ (5.3 mm [.2 inch] for

the top and 9 mm [.35 inch] for the bottom). In this case you may

need to adjust your top and bottom margin settings through your

software or by adjusting the top-of-form position. See your

LQ-570e User's Guide.

Adjusting the Loading (Top-of-Form) and Tear-off

Positions with Micro Adjust

The LQ-570+ micro-feed feature is now called the Micro Adjust

mode on the LQ-570e. To adjust the top-of-form or tear-off

position, make sure paper is loaded in the printer. Then hold

down the Pause button for 3 seconds to enter Micro Adjust

mode. Make sure the Pause light is flashing. Then press the

Load/Eject

are done, press Pause again.

The LQ 570e has no DIP switches. The functions defined by DIP

switch settings on the LQ-570+ are now selected through the

Default Setting Mode on the LQ-570e. See the following section.

or LF/FF

button to adjust the position. When you