Crow EDS-2000 설치 지침 및 사용자 설명서 - 페이지 16
{카테고리_이름} Crow EDS-2000에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Crow EDS-2000 20 페이지. Outdoor pir + mw detector
Crow EDS-2000에 대해서도 마찬가지입니다: 설치 지침 및 사용자 설명서 (20 페이지)
페이지 인쇄
10 Test procedure
Walk Test
Make sure LED's control is set to "ON"
Allow 30 seconds of warm up time.
Make sure that the protected area is cleared of all people.
Start walking across the detection zone.
Look at the LED's whenever motion is detected - all LED's are turned ON.
Allow 5 sec. between each test for the detector to stabilize.
Upon installation, the unit should be thoroughly tested to verify proper operation.
Walk across the entire area where coverage is desired. Should the coverage be incomplete,
readjust sensitivity or relocate the detector.
Once coverage is as desired the LED's may be disabled.
NOTE: Walk Test procedure should be conducted, at least once a year, to confirm
proper operation and coverage of the detector.
16