Epson R1400 조립 지침 매뉴얼 - 페이지 15

{카테고리_이름} Epson R1400에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson R1400 21 페이지. Eco-flo continuous ink system

Please ensure that the tubing has just enough slack which may need to be adjusted to allow movement of the print

head without restriction. This can be done manually by moving the head to the left and right and checking that

there is just enough tubing to allow the print head to move freely from left to right, see Fig.39 below.

Fig.39

Step 15 Install Final Tube Clip

The last tube clip goes on the left edge of the printer housing see Fig.40 below. Clean this area with alcohol

and wipe dry with a paper towel. DO NOT FULLY OPEN THE TUBE CLIP BACK AS THIS WILL SNAP!

Place the Tube Clip onto the printer body, making sure it is in the correct position to hold the tubes in

a straight line along the length of the printer to the Tube Support Bracket.

All the tubes must lay flat so they do not interfere with print head motion, see Fig.41 below. You must ensure that the

tubes do not come into contact with the printer body. When you are happy with the location, remove the adhesive

backing from the back of the clip. Carefully install and align the tube clip in its location.

Fig.40

Fig.41