Crow FW2-SIREN2CP-8/9F 설치 매뉴얼 - 페이지 15

{카테고리_이름} Crow FW2-SIREN2CP-8/9F에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Crow FW2-SIREN2CP-8/9F 19 페이지. Siren system

- User Guide

5. Use a 8 mm bit to drill the holes

6. Fix the unit onto the installation surface.

7. Ensure that the Piezo Siren is connected to the Piezo connector (as shown

below).

8. Insert the battery into the battery clip and connect it to the BAT connector

(shown above).

Note: The battery shall be Installed/replaced by service man

The Siren will beep once and then the LED power will blink for a period of 30 seconds,

please wait to the end of the blinking before activating or learning.

Battery

Address Jumpers

12 Volt Connector

PIEZO Siren Connector

Battery Connector

Figure 5: Siren Connectors

Figure 4: Open Siren Unit