EPSON Stylus COLOR 740
Interfaces
Parallel interface
Forward channel
Specification
Description
Data format
8-bit parallel, IEEE-1284 compatibility mode
Synchronization
STROBE pulse
Handshake timing
BUSY and ACKNLG signals
Signal level
TTL compatible
Connector
57-30360 Amphenol connector or equivalent
Reverse channel
Specification
Description
Transmission mode
IEEE-1284 Nibble mode
Adaptable connector
57-30360 Amphenol connector or
equivalent
Synchronization
Refer to the IEEE-1284 specification
Handshaking
Refer to the IEEE-1284 specification
Signal level
IEEE-1284 Level 1 device
Data transmission timing
Refer to the IEEE-1284 specification
Serial interface
Specification
Description
Standard
Based on RS-423
Synchronization
Synchronous
Bit rate
Approximately 1.8M bps
Handshaking
X-ON/X-OFF and DTR protocol
Word format
Data bit: 8 bits
Parity bit: None
Start bit: 1 bit
Stop bit: 1 bit
Connector
8-pin mini-DIN
Recommended cable
Apple System Peripheral-8 cable (preferably
Belkin brand)
USB interface
Specification
Description
Standard
Based on Universal Serial Bus Specifications
Revision 1.0, Universal Serial Bus Device Class
Definition for Printing Devices Version 1.0
Bit rate
12 Mbps (full speed device)
Data encoding
NRZI
Adaptable connector
USB Series B
Recommended
6.5 feet (2 meters) maximum
cable length
6 - EPSON Stylus COLOR 740
Control Panel
paper out
light
black ink
out light
color ink
out light
Follow these guidelines when the control panel lights come on
or flash:
When the S paper out light flashes, paper is
S
jammed in the printer. Turn off the printer,
remove all the paper (including any pieces torn
off inside), then reload the stack. Turn on the
printer and press the E load/eject button.
When the S paper out light comes on, your
paper ran out or is incorrectly loaded. Load
paper in the feeder and then press the
E load/eject button.
B or A
When an ink out light flashes, your ink supply
is low. Make sure you have a replacement
cartridge.
When an ink out light comes on, you need to
replace the ink cartridge. See "Replacing an Ink
Cartridge" on page 12 for instructions.
P S B A When the P power and S paper out lights
flash and the B black and A color ink out
lights come on, jammed paper may be blocking
movement of the print head. Turn off the
printer, wait a few seconds, and turn it back
on.
When all the lights flash, your printer may have
an internal error. Make sure you removed all
the packing material as described on the
Unpacking Sheet in your printer box. Then
turn off the printer, wait a few seconds, and
turn it on again.
7/98
power
power
button
light
cleaning
load/eject
button
button
페이지 인쇄