EPSON Stylus COLOR 740
Loading Paper
1. Open the output tray and its extensions. Slide the left edge
guide right until it is a little wider than your paper.
2. Load a stack of plain paper with the printable side up and
place it against the right edge guide. Then slide the left edge
guide up against the paper's left edge. Don't load paper
higher than the arrow on the guide.
Load paper only up to
this arrow
Testing the Printer
You can run a printer operation check to determine whether
the problem comes from the printer or some other source.
If the results are satisfactory, the problem lies in your
software settings, the interface cable, or your computer.
If the check page does not print correctly, you have a
problem with your printer. See the Printer Basics book for
possible solutions.
1. Make sure both the printer and computer are turned off.
2. Disconnect the interface cable from the printer.
8 - EPSON Stylus COLOR 740
Slide paper against the
right edge guide
7/98
3. Make sure paper is loaded in the printer.
Caution:
Load paper that's at least 8.27 inches (210 mm) wide.
This prevents ink from spraying inside the printer and
smudging your printouts.
4. Hold down the E load/eject button and press the P power
button. Hold down the E load/eject button until the
P power light starts to flash, then release it.
The printer prints its ROM version number and a nozzle
check pattern (shown in "Examining the Nozzle Check
Pattern" on page 14).
5. To end the check, turn off the printer. Then reconnect the
interface cable and turn on your printer and computer.
Confirming the Printer ID Number
If you're using Windows 95, 98, or NT, you can use the
Printer and Option Information utility to confirm the Printer
ID. Color quality may improve after you confirm the ID
number.
If you're using Status Monitor 2, this information is updated
automatically. However, if a message appears prompting you
to enter settings or if you change the printer's configuration,
you'll need to update the Printer ID manually.
1. Make sure letter-size paper is loaded in your printer.
2. Access the main printer settings dialog box.
3. Click the
tab. Then click the
Utility
icon.
Information
4. Click the
Settings Sheet
Printer ID on a sheet of paper.
5. Make sure the Printer ID shown in the Printer and Option
Information dialog box matches the ID on the Settings
Sheet. If they don't match, change the ID numbers in the
dialog box to match those on the Settings Sheet.
6. Click
to exit and save your settings.
OK
Printer and Option
button. The printer prints the
페이지 인쇄