Epson Stylus Color 740 Manuel d'information sur les produits - Page 8

Imprimer la page

EPSON Stylus COLOR 740

Loading Paper

1. Open the output tray and its extensions. Slide the left edge

guide right until it is a little wider than your paper.

2. Load a stack of plain paper with the printable side up and

place it against the right edge guide. Then slide the left edge

guide up against the paper's left edge. Don't load paper

higher than the arrow on the guide.

Load paper only up to

this arrow

Testing the Printer

You can run a printer operation check to determine whether

the problem comes from the printer or some other source.

If the results are satisfactory, the problem lies in your

software settings, the interface cable, or your computer.

If the check page does not print correctly, you have a

problem with your printer. See the Printer Basics book for

possible solutions.

1. Make sure both the printer and computer are turned off.

2. Disconnect the interface cable from the printer.

8 - EPSON Stylus COLOR 740

Slide paper against the

right edge guide

7/98

3. Make sure paper is loaded in the printer.

Caution:

Load paper that's at least 8.27 inches (210 mm) wide.

This prevents ink from spraying inside the printer and

smudging your printouts.

4. Hold down the E load/eject button and press the P power

button. Hold down the E load/eject button until the

P power light starts to flash, then release it.

The printer prints its ROM version number and a nozzle

check pattern (shown in "Examining the Nozzle Check

Pattern" on page 14).

5. To end the check, turn off the printer. Then reconnect the

interface cable and turn on your printer and computer.

Confirming the Printer ID Number

If you're using Windows 95, 98, or NT, you can use the

Printer and Option Information utility to confirm the Printer

ID. Color quality may improve after you confirm the ID

number.

If you're using Status Monitor 2, this information is updated

automatically. However, if a message appears prompting you

to enter settings or if you change the printer's configuration,

you'll need to update the Printer ID manually.

1. Make sure letter-size paper is loaded in your printer.

2. Access the main printer settings dialog box.

3. Click the

tab. Then click the

Utility

icon.

Information

4. Click the

Settings Sheet

Printer ID on a sheet of paper.

5. Make sure the Printer ID shown in the Printer and Option

Information dialog box matches the ID on the Settings

Sheet. If they don't match, change the ID numbers in the

dialog box to match those on the Settings Sheet.

6. Click

to exit and save your settings.

Printer and Option

button. The printer prints the