Epson Stylus Color 880 설정 매뉴얼 - 페이지 5

{카테고리_이름} Epson Stylus Color 880에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Stylus Color 880 17 페이지. Product support bulletin(s)
Epson Stylus Color 880에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 제품 지원 게시판 (6 페이지), 제품 지원 게시판 (1 페이지), 제품 정보 시트 (4 페이지), 사양 (2 페이지), 여기에서 시작 (4 페이지), 사용자 설명서 (13 페이지), 제품 지원 게시판 (3 페이지), 제품 지원 게시판 (2 페이지), 제품 지원 게시판 (4 페이지), 제품 지원 게시판 (7 페이지), 빠른 시작 매뉴얼 (2 페이지)

Follow the instructions in the appropriate section below to install the printer

software. If you are DOS user, see "Printing with DOS" in the Daily Use

guide.

For Windows 98, 95, 2000, and NT 4.0 users

Windows 98, 95, 2000, and NT 4.0 users must first install the printer

software, and then, if you are connecting via the USB port, check to ensure

that the USB cable is correctly installed. If you are connecting via the parallel

port, proceed to section

Installing the software

Follow the steps below to install the printer software.

Make sure that your printer is off.

Turn on your computer and start Windows. If the New Hardware

Found screen or any other Wizard appears, click Cancel.

Insert the printer software CD that is shipped with your printer in the

CD-ROM drive. The Installer dialog box opens. (For floppy disk users,

insert the disk in the disk drive and double-click the My Computer

icon, the floppy disk drive icon, and then Setup.exe.)

Select Install Printer Driver/Utility

and click

dialog box that appears to start the

printer software installation.

Note:

It is possible to install the Reference

Guide on your hard drive from the

Installer dialog box, as shown at the

right. To install the guide, select Online

Guide and then click

Install Reference Guide and follow

the on-screen instructions. When the

installation is complete, an ESC880

Guide icon appears in the EPSON folder. Double-click the icon to open the

guide.

Follow the on-screen instructions to turn on your printer.

For Windows 98 users, the printer port configuration starts

automatically.

For printers connected via USB cable, the USB device driver installation

starts automatically at this point. A message will appear asking you to

restart your computer. Follow this instruction.

Nagano, Japan.

after installing the software.

. Then, click OK in the

. Then, click

Printed in Japan.xx-xx