Dill TPMS 1502 사용 설명서 - 페이지 11

{카테고리_이름} Dill TPMS 1502에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dill TPMS 1502 16 페이지. Trailer kit

1. Check your antenna connection.

2. Drive your vehicle over 20mph for 3 to 5 minutes.

"wake" the transmitter and begin to transmit a signal to your

display unit.

If the display unit is working properly and it still does not receive a signal from

the transmitter(s), then the transmitter(s) and ID module(s) must be replaced

simultaneously.

A replacement transmitter and ID module can be purchased from a Dill

distributor or retailer, list available at www.trailertpms.com.

3.7 Antenna Installation (Optional) and RF Interference*

If the display unit is receiving a signal on an intermittent basis, i.e. when the

distance is greater than what is recommended or there is interference

preventing a continuous signal reaching the display from the wheel, you will

need to install an exterior antenna. The added benefit of an exterior antenna is

to assure a better reception from your transmitters to the display/receiver.

The antenna is assembled with an industrial strength magnet, 19 feet of coaxial

wire, and a coaxial connector to install into the back of your display/receiver.

19' COAXIAL

WIRE

ANTENNA

MAGNET

NOTE: MAGNETIC

STRENGTH WILL ADHERE

QUICKLY TO ANY METALLIC

OBJECTS. KEEP FINGERS

AWAY FROM THE BOTTOM

OF THE MAGNET.

DISPLAY/RECEIVER

CONNECTOR

This will