Dill TPMS 1502 Руководство по эксплуатации - Страница 11

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Автомобильные аксессуары Dill TPMS 1502. Dill TPMS 1502 16 страниц. Trailer kit

1. Check your antenna connection.

2. Drive your vehicle over 20mph for 3 to 5 minutes.

"wake" the transmitter and begin to transmit a signal to your

display unit.

If the display unit is working properly and it still does not receive a signal from

the transmitter(s), then the transmitter(s) and ID module(s) must be replaced

simultaneously.

A replacement transmitter and ID module can be purchased from a Dill

distributor or retailer, list available at www.trailertpms.com.

3.7 Antenna Installation (Optional) and RF Interference*

If the display unit is receiving a signal on an intermittent basis, i.e. when the

distance is greater than what is recommended or there is interference

preventing a continuous signal reaching the display from the wheel, you will

need to install an exterior antenna. The added benefit of an exterior antenna is

to assure a better reception from your transmitters to the display/receiver.

The antenna is assembled with an industrial strength magnet, 19 feet of coaxial

wire, and a coaxial connector to install into the back of your display/receiver.

19' COAXIAL

WIRE

ANTENNA

MAGNET

NOTE: MAGNETIC

STRENGTH WILL ADHERE

QUICKLY TO ANY METALLIC

OBJECTS. KEEP FINGERS

AWAY FROM THE BOTTOM

OF THE MAGNET.

DISPLAY/RECEIVER

CONNECTOR

This will