Dillon ED-2000plus 사용자 설명서 - 페이지 13

{카테고리_이름} Dillon ED-2000plus에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dillon ED-2000plus 20 페이지. Electronic dynamometer with hr-2000 remote

페이지 인쇄

Operation

Key

ON/OFF

F + ON/OFF

(while unit is off)

F+ ON/OFF

(while unit is on)

PEAK HOLD

TEST

F + PEAK/HOLD

F + TEST

F + ON/OFF

ON/OFF

ALT + ON (while unit is off)

F + ALT

UNITS

Powering Up

For Radio Communication

While operating the HR-2000,

the lower part of the leftmost

digit may be observed to flash.

This occurs when the HR-2000

wants to transmit a message

and is waiting for access or for

an answer. Operating under

good radio conditions, this will

be rarely seen.

The key functions for the HR-2000 are listed in Table 6.

Function

Turns the unit on in radio mode. RS-485 wireline communi-

cation will also function.

Press these two keys to power up the unit in RS-485

wireline mode. This disables radio function and preserves

battery life.

Puts the unit into addressing mode and shows the address

that is to be polled.

Increments the address by 1 count.

Decrements the address by 1 count

Increments the address by 10

Decrements the address by 10

Returns unit to normal display mode.

Turns the unit off

Forces unit into RS-232 mode

Places remote in LISTEN mode. The remote waits for a poll

signal from the attached peripheral, requests the reading

from the ED-2000plus and returns the reading to the periph-

eral.

Press this to save changes and move to the next item.

Hold the UNITS key to see the item name, release it to see

the value.

Table 6

Key Functions for HR-2000

To power up for use with the radio link, press the ON/OFF key on the

ED-2000plus then the press the ON/OFF key on the HR-2000.

When you turn on the HR-2000 for radio use, the display will show the

software revision number (probably hr2001), then the word rAdio. Until the

corresponding ED-2000plus is powered up and communicating with the

HR-2000, the letter r will flash back and forth between inverted and upright.

When communication is established and working properly the display will

mirror the ED-2000plus display and the leftmost decimal point will blink every

½ second. If communication is broken, the display will flash a small o in the

lower left corner of the display. If communications are not resumed within ten

seconds, the display will show rAdio and the letter r will flash back and forth

between inverted and upright.

Display

rAdio

rS-485

SEtuP-100

101

110

-donE-

OFF

-duAL-

LiStEn

See Table 7

headings