Dillon GTS-1000 운영자 매뉴얼 - 페이지 10
{카테고리_이름} Dillon GTS-1000에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dillon GTS-1000 16 페이지.
페이지 인쇄Crosshead
The crosshead has six mounting holes for attaching a gauge with twin 2.25 inch (57
mm) hole spacing. The maximum stand capacity is dependent upon which position the
force gauge is mounted to.
Gauge mounting position
A (closest to column)
B (middle)
C (furthest from column)
Connectors
Three 15-pin connectors are on the rear of the stand.
Position
Top (n/c)
Middle (GTX)
Bottom (PC)
Overview of controls
The GTS-1000 front console has three basic
sections:
#1 Operating mode
#2 Test speed
#3 Move
Additional controls include:
-
Emergency stop button (above console)
-
Crosshead travel limit switches (on column)
-
On/off power switch (at rear of stand)
Throat opening
2.64 inch / 67 mm
3.82 inch / 97 mm
5.00 inch / 127 mm
Use
No connection. Factory and dealer use only.
Connect to a Dillon GTX force gauge for stand reverse/stop control
on sample break or compression overload.
Sends the GTX serial information to a computer when the stand
reverse/stop cable above is used.
expansion boxes required by other brands.
OPERATION
Maximum stand capacity
1000 N / 220 lbf / 100 kgf
750 N / 165 lbf / 75 kgf
500 N / 110 lbf / 50 kgf
The PC port eliminates Y-cables or
10