Acuity Controls nLight nPOD 2P 설치 - 페이지 2

{카테고리_이름} Acuity Controls nLight nPOD 2P에 대한 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Acuity Controls nLight nPOD 2P 2 페이지. Wallpod: 2-channel on/off low voltage

페이지 인쇄
Acuity Controls nLight nPOD 2P 설치
WIRING
TYPICAL WIRING
Power to WallPod device is provided via the CAT-5e connection to an nLight power pack/supply or Bridge. T568B pin/pair assignment is recommended for
all CAT-5e cables.
ON/OFF
CAT-5
GROUND
3-WAY CONFIGURATION WIRING
CAT-5
INSTALLATION
•
Mount WallPod using holes that align with standard single gang switch box or
low voltage ring.
•
Connect green screw to ground.
•
Access RJ-45 ports by sliding trapdoor up.
•
Insert CAT-5 cable(s) through opening and route out through cutouts in rear of
WallPod.
•
Secure cable(s) by sliding trapdoor back into orignal place
•
Interconnect unit with other nLight devices in lighting zone using CAT-5 cables.
•
Once power is received via CAT-5 connection, all devices in zone will
automatically begin functioning together according to each device's defaults.
Attention! Only use non-booted CAT5e cables.
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitycontrols.com
© 2014-2016 Acuity Brands Lighting, Inc. All rights reserved. Rev. 06/06/16
BLK
ORN
nPP16
LOAD 1
CAT-5C
nPP16
CAT-5
CAT-5
CAT-5
nPP16
CAT-5
-
120 V
-
277 V
nPP16
AT-5
CAT-5
BLK
-
120 V
ORN
-
277 V
LOAD 1
BLK
-
120 V
ORN
-
277 V
LOAD 2
BLK
-
120 V
ORN
-
277 V
LOAD 2
CAT-5
LOAD 1
GROUND
CAT-5
LOAD 2
CAT-5
GROUND
nPODM-2P
2 of 2