AEMC instruments Measure Up PowerPad III 빠른 시작 매뉴얼 - 페이지 10
{카테고리_이름} AEMC instruments Measure Up PowerPad III에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEMC instruments Measure Up PowerPad III 17 페이지. Power quality analyzer
페이지 인쇄
Installation of the Leads and Current Sensors
Color-coded ID markers are supplied with the PowerPad
terminals.
• Detach the appropriate inserts from the color-coded marker and place them in the
holes provided under the terminals (larger inserts for current terminals, smaller inserts
for voltage terminals).
• Clip the rings of the same color to the ends of the lead that will connect to the terminal.
SD-Card
SD-Cards are supported. Note that the instrument's recording capacity is 2 GB maximum.
To Access the SD-Card:
• Make sure that the instrument is disconnected and off.
• Use a screwdriver or coin to unscrew the two screws of the battery compartment
cover.
• Remove the cover and withdraw the battery from its compartment without disconnect-
ing it.
• Press on the SD-Card to release it then press on the protecting tab to withdraw it from
its slot.
• When replacing the SD-Card, the contacts must be on the left side, and the locator
down.
• Slide it into its slot until it snaps into place. The protecting tab is at the top of the card.
• Put the battery back in its compartment and screw the cover back on.
to identify the leads and input
®