AEMC instruments Measure Up PowerPad III Краткое руководство по эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Измерительные приборы AEMC instruments Measure Up PowerPad III. AEMC instruments Measure Up PowerPad III 17 страниц. Power quality analyzer
Печатать страницу
Installation of the Leads and Current Sensors
Color-coded ID markers are supplied with the PowerPad
terminals.
• Detach the appropriate inserts from the color-coded marker and place them in the
holes provided under the terminals (larger inserts for current terminals, smaller inserts
for voltage terminals).
• Clip the rings of the same color to the ends of the lead that will connect to the terminal.
SD-Card
SD-Cards are supported. Note that the instrument's recording capacity is 2 GB maximum.
To Access the SD-Card:
• Make sure that the instrument is disconnected and off.
• Use a screwdriver or coin to unscrew the two screws of the battery compartment
cover.
• Remove the cover and withdraw the battery from its compartment without disconnect-
ing it.
• Press on the SD-Card to release it then press on the protecting tab to withdraw it from
its slot.
• When replacing the SD-Card, the contacts must be on the left side, and the locator
down.
• Slide it into its slot until it snaps into place. The protecting tab is at the top of the card.
• Put the battery back in its compartment and screw the cover back on.
to identify the leads and input
®