diLUSSO OV608SDS 설치 및 운영 매뉴얼 - 페이지 17

{카테고리_이름} diLUSSO OV608SDS에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. diLUSSO OV608SDS 18 페이지. Side opening door built-in oven

10) TELESCOPIC RACKS ASSEMBLY

To assemble the telescopic arms :

Warning:

1. Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electrical shock.

2. Accessible parts may become hot during use. Young children should be kept away.

3. Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch

the surface, which may result in shattering of the glass.

4. Steam cleaner is not to be used.

5. Fixed wiring must be protected.

6. The door should be situated more than 85 mm above floor after installation of the oven.

7. Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.

8. When it is in use the appliance becomes hot. Care should be taken to avoid touching heating elements inside

the oven .

Version 1.0

Remove the two frames, lifting them away from spacers A

Choose which shelf to use with the telescopic arms. Pay

attention to the direction in which the telescopic arms is to be

extracted. Position joint B and the joint C on the frame.

Secure the two frames with the guide rails using the holes

provided on the oven walls. The holes for the left frame are

situated at hole F1, F2, and the right frame at hole D1, D2.

Finally fit the frames on spacers A.

Page 16

May 2021