Motorola CLS1410 사용자 설명서 - 페이지 17

{카테고리_이름} Motorola CLS1410에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola CLS1410 30 페이지. Cls series two-way radio
Motorola CLS1410에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)

페이지 인쇄

Programming Microphone Gain

You can adjust the microphone sensitivity to suit different users or operating

environments.

1. In programming mode, press

2. Press [ or ] to select the sensitivity level:

3 = High sensitivity, for quiet environments

2 = Medium sensitivity (default)

1 = Low sensitivity, for loud environments

3. Press and hold Push to Talk to exit programming mode, or press

programming.

Editing the Scan List (CLS1410 Only)

For faster scanning and to avoid hearing unwanted transmissions, you can edit the

scan list to skip channels.

1. In programming mode, press

number and Y or n flash.

2. Press [ or ] to select the channel you want to remove from the

scan list.

3. Press

to display either Y to include the channel or n to exclude

the channel.

4. Press and hold Push to Talk to exit programming mode, or press

programming.

Cloning Radio Settings

You can copy _ Series radio settings from one radio (the source) to a second

radio using the 56531 Multi-Unit Charger (MUC) optional accessory. See the MUC

User's Guide for more information.

You can clone only one radio at a time. A multi-channel radio can clone to a single-

channel radio, but only the first channel is cloned. The MUC does not have to be

plugged in for cloning, but both radios require charged batteries.

1. On the source radio, press and hold Push to Talk and

turning the radio on. The radio beeps and displays k.

2. Place the source radio in one of the charging pockets.

3. Turn the target radio on and place it in the charging pocket

that is paired with the pocket containing the source radio.

There are 3 paired charging pockets as indicated by the

3 pairs of charging status LEDs.

4. Press and hold

transmits its settings to the target radio. If cloning was

successful, P or Pass or "F" for Fail displays on the source

radio and the target radio displays all feature icons. If cloning

was not successful, F or Fail displays on the source radio.

5. Turn the target radio off and back on again to use.

6. To clone another radio, repeat steps 3 and 4.

7. To exit programming mode on the source radio, press and hold Push to Talk

until k no longer appears.

until g and ? display.

until h displays and the channel

on the source radio. The source radio

to continue

for 3 seconds while

Paired

pockets

LEDs