Epson Equity 386SX PLUS 제품 지원 게시판 - 페이지 15
{카테고리_이름} Epson Equity 386SX PLUS에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Equity 386SX PLUS 26 페이지. Product support bulletin(s)
Epson Equity 386SX PLUS에 대해서도 마찬가지입니다: 제품 지원 게시판 (19 페이지), 제품 정보 매뉴얼 (10 페이지), 제품 정보 매뉴얼 (10 페이지), 제품 지원 게시판 (45 페이지)
페이지 인쇄
What hard drive controller is used in the 386SX PLUS?
The 386SX PLUS uses a controller embedded on the hard drive. This
controller connects to a Task File Host interface (IDE) that is integrated in the
system board.
Can the 386SX PLUS use other hard disk drives and controllers?
Yes, the Host Interface on the system board can be disabled and other third
party hard drive controllers and drives can be used. The interface can be
disabled by setting Jumper J2 to position A. Other embedded controller AT-
type drives can also be used with the Host Interface.
What extended hard drive support is available in the ROM BIOS that comes
with the Epson 386SX PLUS?
The Seiko-Epson BIOS will directly support hard drives that range in size from
10MB to 153MB. There is direct support for the Seagate ST-251 as well as
several ESDI drives. By providing this support for 3rd party hard disk drives,
the Equity SX PLUS has the capability to use most 3rd party &bit and 16-bit
hard disk controllers. SCSI drives have their own controllers attached to the
drive and should work correctly when attached to the bus with a host adapter.
The 386SX PLUS also has a User Definable setting that allows you to set up
hard disk drives that are not supported by the 386SX PLUS Drive Type Table.
in SETUP, a sub-menu lists the settings you can change for each drive: the
number of cylinders (tracks), the number of read/write heads, the number of
sectors, the precompensation cylinder, the landing zone (the cylinder on
which you want to park the heads when moving the computer), and the total
storage capacity in megabytes. This allows you to use hard drives much
larger than 153MB.
FLOPPY DRIVES:
Q23. What types of floppy disk drives will work on the 386SX PLUS?
A
The 386SX PLUS comes standard with either a 5.25" 1.2MB or 3.5" 1.44MB
floppy disk drive. There is built-in BIOS support for industry standard 360KB
and 1.44MB, 3.5" half-height floppy disk drives as well as the 720KB, 3.5"
floppy drive. All four drive sizes are available from Epson.
Q24. Will the 386SX PLUS support 3 floppy disk drives?
A
No, not directly. The Epson controller and ROM BIOS supports a maximum of
two floppy drives.
PSB No: S-0131
Page: 6 of 9