Epson Equity LT-286e 제품 지원 게시판 - 페이지 10

{카테고리_이름} Epson Equity LT-286e에 대한 제품 지원 게시판을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson Equity LT-286e 15 페이지. Proper method for running benchmark and diagnostics programs using the manzana driveport third party memory boards
Epson Equity LT-286e에 대해서도 마찬가지입니다: 제품 정보 매뉴얼 (7 페이지)

페이지 인쇄

Q18. How do I use an external CRT with my LT - 286e?

You can connect a monitor to the video interface (DB - 9) on the side of

the unit.

LCD and an external CRT display.

monochrome, CGA and EGA monitors. For best results, a TTL

monochrome monitor should be installed for software as "640 x 350 EGA

MONO".

Hard Disk Drives

Q19. What capacity hard drives come with the LT- 286e?

Either a 20 MB type 2 (A811221) or a 40 MB type 17 (A811231).

Q20. Can I install the hard drive myself?

Yes. Open the computer and remove the blank cartridge from the left side

above the keyboard. Grasp the hard drive cartridge with the "PUSH" button

to the left. Lower the cartridge squarely into the drive bay, using the keyed

slots to locate it correctly. As it seats, press down firmly but carefully until

the cartridge locks in place. Turn the computer on and run SETUP to

select the correct drive type. If it's a new drive, it will need to be

partitioned and formatted before use.

Q21. What is the "SHOCK WATCH" indicator on the bottom of the hard drive

cartridge?

The hard drive cartridge is a delicate device. The shock watch capsule is

a precautionary device to let you know if a drive has received an excessive

physical shock. For example, the shock watch capsule would turn from

clear to red if a drive was dropped approximately 2-4 feet on thin carpet.

It does not mean that the drive is definitely damaged - it simply lets you

know that it has received a shock and should be thoroughly tested by a

Customer Care Center before further use.

Q22.

Does the hard disk drive (HDD) automatically park the heads in the landing

zone when the LT- 286e is turned off?

Yes. The HDD automatically parks the heads when the unit is turned off.

A slide switch beneath the unit lets you change between the

PSB No: S-0104

Page: 4 of 7

The LT- 286e supports TTL