Motorola EMS APX 7500 사용자 설명서 - 페이지 26
{카테고리_이름} Motorola EMS APX 7500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola EMS APX 7500 44 페이지. Multiband mobile radio
Motorola EMS APX 7500에 대해서도 마찬가지입니다: 브로셔 (8 페이지), 제품 사양서 (5 페이지)
페이지 인쇄
Changing Priorities Status While Scan is On
While the radio is scanning, the dynamic priority change feature
allows you to temporarily change any channel in a scan list
(except for the Priority-One channel) to the Priority-Two
channel.
This change remains in effect until scan is turned off. Scan then
reverts to the preprogrammed (original) setting.
Procedure:
1
Press the Menu Select button directly below DYNP to
change the priority of a non-priority channel in the scan list
to Priority-Two.
2
H
Press
momentarily to exit the scan list and resume
scanning.
Restoring Priorities in a Scan List
Procedure:
To restore the original channel priorities in a scan list, do one of
the following:
•
Turn scan off, then on.
OR
•
Change channels.
OR
•
Turn off the radio, and then turn it back on.
Hang Up Box (HUB)
To temporarily suspend Scan Mode operation, remove the
control head from the Hang Up Box (HUB). You are allowed to
use the control head while scan is suspended. However, Priority
Member scanning is not suspended. This feature applies to all
Scan Lists and Scan Types. Scan is resumed once the control
head is returned to the holding clip and the preprogrammed
hang time has elapsed.
Note:
Priority Scan List members are continuously scanned
only when the Scan List, Designated Tx Member field
is set to "Talkback" in the radio programming.
Otherwise, all scan mode operation is suspended.
11/2/15
26
English