Motorola Professional GP640 서비스 정보 - 페이지 9
{카테고리_이름} Motorola Professional GP640에 대한 서비스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola Professional GP640 28 페이지. Professional radio, power distribution and controller
Motorola Professional GP640에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지), 사양 시트 (2 페이지), 서비스 정보 (32 페이지), 서비스 정보 (30 페이지), 서비스 정보 (26 페이지), 서비스 정보 (43 페이지), 서비스 정보 (30 페이지)
페이지 인쇄
1.0
Introduction
This Chapter provides a detailed theory of operation for the UHF2 circuits in the radio. For details of
the theory of operation and trouble shooting for the the associated Controller circuits refer to the
Controller Section of this manual.
2.0
UHF2 Transmitter
( Refer to Figure 2-1 and the UHF Transmitter schematic diagram )
The UHF2 transmitter consists of the following basic circuits:
1.
Power ampliÞer (PA).
2.
Antenna switch/harmonic Þlter.
3.
Antenna matching network.
4.
Power Control Integrated Circuit (PCIC).
From
VCO
2.1
Power AmpliÞer
The power ampliÞer (PA) consists of two principle devices:
1.
LDMOS PA driver IC, U101.
2.
LDMOS PA Þnal stage, Q110.
The LDMOS driver IC provides 2-stage ampliÞcation using a supply voltage of 7.3V. The ampliÞer is
capable of supplying an output power of 0.3W (pins 6 and 7) with an input signal of 2mW at 3dBm
(pin16). The current drain is typically 160mA while operating in the frequency range of 450-527MHz.
P C I C
Vcontrol
Power
Amplifier
PA
Driver
Figure 2-1 UHF2 Transmitter Block Diagram.
THEORY OF OPERATION
Vcontrol
Antenna Switch/
PA Final
S t a g e
Harmonic Filter
Chapter 2
Antenna
Matching
Network