Motorola Professional GP640 서비스 정보 - 페이지 11

{카테고리_이름} Motorola Professional GP640에 대한 서비스 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Motorola Professional GP640 28 페이지. Professional radio, power distribution and controller
Motorola Professional GP640에 대해서도 마찬가지입니다: 사용자 설명서 (32 페이지), 사양 시트 (2 페이지), 서비스 정보 (32 페이지), 서비스 정보 (30 페이지), 서비스 정보 (26 페이지), 서비스 정보 (43 페이지), 서비스 정보 (30 페이지)

페이지 인쇄

UHF2 Receiver

3.0

UHF2 Receiver

The UHF2 receiver consists of a front end, back end, and automatic gain control circuits. A block

diagram of the receiver is shown in Figure 2-2. Detailed descriptions of these features are contained

in the paragraphs that follow.

Antenna

Pin Diode

Antenna

Switch

RF Jack

3.1

Receiver Front-End

( Refer to Figure 2-2 and the UHF2 Receiver Front End schematic diagram)

The RF signal received by the antenna is applied to a low-pass Þlter. For UHF, the Þlter consists of

components L101, L102, C102, C103, and C104. The Þltered RF signal is passed through the

antenna switch circuit consisting of two pin diodes (CR101 and CR102) and a pi network (C106,

L104, and C107). The signal is then applied to a varactor tuned bandpass Þlter.

The UHF bandpass Þlter consists of components L301, L302, C302, C303, C304, CR301, and

CR302. The Þlter is electronically tuned by DACRx from IC 404 which supplies a control voltage to

the varactor diodes (CR301 and CR302) in the Þlter as determined by the microprocessor

depending on the carrier frequency. Wideband operation of the Þlter is achieved by shifting the

bandpass Þlter across the band.

Varactor

RF Amp

Tuned Filter

First LO

from FGU

Control Voltage

from ASFIC

Recovered Audio

Squelch

RSSI

16.8 MHz

Reference Clock

Figure 2-2 UHF2 Receiver Block Diagram.

Varactor

Tuned Filter

AGC

Demodulator

SPI Bus

Crystal

Mixer

Filter

Synthesizer

Second

LO VCO

2-3